4/27/2023 0 Comments Juniper srx vpn monitor![]() Select Internet Mode NAT and then select OK.Select Edit for the interface that connects to the LAN.Įnter the address of the interface that connects to the LAN: 192.168.2.99, for example.Refer to Juniper documentation for detailed information. ![]() This Juniper SSG appliance is configured using its WebUI. The incoming policy allows hosts on the network behind the Juniper appliance to communicate with hosts behind the FortiGate unit. To prevent unencrypted data from leaving the FortiGate, refer to KB article:- FortiOS Protecting data for muliple subnets when IPSec Tunnel FailsĬonfigure FortiGate Incoming Firewall Policy Using the example configuration, enter the following commands: config firewall policy The firewall address of the remote network: Site2_net The interface that connects to the remote network: toSSG The firewall address of the local network: LocalLAN The interface connected to the local network: internal Go to Firewall > Policy and select Create New.The outgoing policy allows hosts on the network behind the FortiGate unit to communicate with hosts behind the Juniper appliance. To configure using the CLIUsing the example configuration, enter the following commands: config firewall addressĬonfigure FortiGate Outgoing Firewall Policy "Site2_net" for the network behind the Juniper appliance "LocalLAN" for the network behind the FortiGate unit Go to Firewall > Address and select Create New.Using the example configuration, enter the following commands: config vpn ipsec phase2-interfaceĬreate firewall addresses for the private networks at either end of the VPN. Go to VPN > IPSec > Auto-Key and select Phase 2.Ī name for the VPN Phase 2 configuration: Tunnel-FG-SSG, for example.Set psksecret ENC XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX Using the example configuration, enter the following commands: config vpn ipsec phase1-interface Select Advanced and enter the following:ġ - Encryption 3DES, Authentication SHA1 (default).Same preshared key configured on the Juniper appliance The interface that connects to the remote VPN: WAN1 The public IP address of the Juniper appliance, Go to VPN > IPSec > Auto-Key and select Phase 1.The FortiGate unit and the Juniper SSG unit must be in NAT mode.Juniper Networks SSG with firmware version 6.0.0r3.0.FortiGate unit running FortiOS v3.0 firmware, MR5 or later.The example shown here is route-based, but a policy-based VPN is also possible. This article describes how to configure an IPSec VPN on a FortiGate unit to work with a Juniper Networks Secure Services Gateway (SSG).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |